HyperSentinel · Engine

Connect

Connect MetaMask to see balances. Trading approval is separate from funding.

1

Connect wallet

MetaMask by default · wallet and network shown immediately

2

Approve the agent key gasless

available after sign-in · trading permission, not withdrawal permission

Connect to read your balances. Trading can lose money; non-custodial does not mean risk-free.

USDG in. USDG out.

Minimum trading balance: 20 USDC after costs. You confirm each movement in MetaMask.

Your source and destination wallet: not connected

USDG to send from Robinhood Chain $0.50 gas reserve for deposits and withdrawals. Allocate about $0.50 from this USDG amount to ETH in your Arbitrum wallet for the Hyperliquid deposit and return transfer. Unspent ETH stays yours. Robinhood gas and bridge / Hyperliquid fees are separate.

20 USDC is the starting balance requirement. Each copied entry must also reach the exchange's $10 order minimum after proportional sizing and rounding. Smaller entries are skipped; a small funded account may make no trades.

HyperCore trading does not require HYPE for gas. Keep ETH on Robinhood for the USDG transfer, and ETH on Arbitrum for deposit / return transfers. Complete USDC deposits and withdrawals on Hyperliquid, then refresh your balance here. Review its current transfer fees before signing; they are separate from the $0.50 ETH reserve.

Review a fresh quote before sending.

2. Open Hyperliquid to deposit USDC ↗

After USDC and ETH arrive on Arbitrum, connect this same wallet on Hyperliquid and review its USDC deposit. Then return here and refresh balances. Allow 1 USDC for activation of a new HyperCore account, plus current transfer fees. Start requires at least 20 USDC actually credited and free.

Bridge funds temporarily pass through third-party contracts. Network, bridge and exchange costs still apply; HyperSentinel service fee is zero.

Recover an interrupted wallet submission

If MetaMask sent the transaction but this tab missed the response, paste its transaction hash. Network, sender, token, amount, destination and nonce must match the saved transfer. Do not send again.

Balances refresh every 15 seconds. Funds are not traded until the engine is activated.

Strategy

What the engine runs on your account.

Pirate — unchanged. Follow actual engine entries and exits, including its whale selection and market gates. No independent short or altcoin strategy is added here.

Auto-close on consensus decay

Whales out — we follow

Stop −6%

Always on

Reinvest profit

Compounds into the next trade size

Size & leverage

Working capital is what sits on your account.

Working capital—

Confirmed source fill × your USDC NAV ÷ source USDC NAV, rounded down to the venue lot size. Small accounts may skip orders below the exchange minimum.

LeverageInherited per instrument

Trade size

—

Slots

10

Stop

−6%

Execution is off until the worker, source feed and your account have passed readiness checks.

Like Pirate, use one USDC balance for main + xyz. This changes collateral handling across your Hyperliquid account. We require an account without existing positions or orders before enrollment.

I will use this Hyperliquid account exclusively for this strategy while it is active.

I accept trading losses, liquidation and execution/bridge risks. Stops do not guarantee a maximum loss. New source entries only; no catch-up trades.

Your controls

Sign in to read strategy status.

Pause stops new entries and keeps protection active. Close positions stops new entries, closes this strategy's positions and cancels its remaining orders; USDC stays on your Hyperliquid account. It does not wait for Pirate's exit signal. Withdrawal to your wallet is a separate signed action. Closing is complete only after the exchange confirms no positions or orders remain. Disconnecting this browser does not stop the strategy.

Revoke the agent / emergency control

Revoking disables this agent but does NOT close positions or cancel existing orders. After revocation you must manage any remaining risk yourself. You can always control your account directly on Hyperliquid.

Direct exchange access ↗

Your positions

live from Hyperliquid

—

account value

Instrument	Side	Size	Entry	Mark	P&L

Waiting for the engine. Positions appear here the moment the engine opens one on your account.

Engine right now

What the composite is holding at this moment.

Instrument	Side	P&L

Settings

Capital—

LeverageInherited per instrument

Auto-closeon

Reinveston

Service fee0

Hyperliquid trading fees and funding still apply. IOC entries and closes take liquidity; fees use the full trade notional, including leverage. Your account's rates and xyz venue fees may differ. HYPE gas is not needed for HyperCore trading. ETH and bridge costs apply to funding and withdrawal routes.

Activity

Your fills, last 7 days.

Start the Engine

Your wallet